BAAN Adjustable Lowering Links for Audi A6 C8 Air Suspension

Lower your Audi A6 C8 with a precise, fully adjustable solution that works together with the original factory air suspension.

The BAAN Airmatic Lowering Links are designed for Audi A6 C8 models equipped with air suspension. By replacing the standard ride height sensor links, the system allows the suspension to maintain a lower vehicle position without installing an electronic lowering controller.

The result is a cleaner, more performance-focused stance while preserving the comfort and versatility of the original Audi suspension system.

Adjustable Audi A6 C8 ride height

The lowering links provide a progressive adjustment range on both axles:

• Front axle: adjustable from 0 to approximately 50 mm
• Rear axle: adjustable from 0 to approximately 50 mm

Because the front and rear links can be adjusted independently, the ride height can be configured to suit the vehicle, wheel setup and preferred stance.

This makes it possible to reduce excessive wheel gap, correct the visual balance between the front and rear axle or create a more pronounced lowered appearance.

Mechanical adjustment through the factory sensors

The Audi A6 C8 air suspension determines the vehicle height through sensors connected to the suspension by small linkages.

The BAAN lowering links replace these factory components with fully adjustable alternatives. Altering the effective length of the links changes the ride height value measured by the sensors. The original suspension controller then adjusts the air suspension to the newly configured position.

No separate suspension control unit is installed and no module needs to be connected to the vehicle’s electronic network.

Why choose BAAN lowering links?

• Vehicle-specific solution for the Audi A6 C8
• Suitable for vehicles with factory air suspension
• Up to approximately 50 mm of adjustable lowering
• Independent front and rear adjustment
• Retains the original Audi suspension controls
• No software changes required
• No electronic module connected to the vehicle
• Ideal for aftermarket wheel and tyre setups
• Remains adjustable after installation
• Original components can be reinstalled if required

Original comfort with a lower stance

The BAAN lowering links change the reference position used by the ride height sensors. They do not replace the factory air springs, dampers or suspension controller.

The original Audi air suspension therefore remains responsible for controlling the vehicle. Its normal suspension functionality and selectable driving settings remain available after the lowering links have been installed.

Installation and adjustment

Installation can usually be completed in approximately one hour by an experienced technician. The final adjustment should be carried out with the vehicle positioned on level ground and checked again after the suspension has settled.

For the best result, we recommend measuring the vehicle at all four corners before and after installation. This allows the ride height to be adjusted accurately and helps create a balanced front-to-rear stance.

BaanVelgen can supply, install and configure the lowering links for your Audi A6 C8.

Frequently asked questions

Do the lowering links replace the Audi air suspension?

No. They only replace the small linkages connected to the original ride height sensors. The factory air suspension remains installed and operational.

What is the maximum lowering range?

The Audi A6 C8 can be lowered by up to approximately 50 mm at both the front and rear axle.

Will I still be able to use the original suspension modes?

Yes. The factory suspension controller and original Audi driving settings remain in use.

Are the links suitable for fine-tuning the stance?

Yes. Each link is adjustable, allowing the front and rear ride height to be configured separately.

Product images are for illustration purposes only. The appearance of the supplied product may vary due to vehicle-specific design updates and continuous product improvement.